Biocide Technical Ingredients
All water based products have plenty of nutrients and water to support microbe growth under favorable conditions. Microbes invade water based products from multi-point sources, such as contaminated raw materials, poor plant hygiene, untreated water, and not properly preserved recycling materials. While adding in-can preservatives into the products should not excuse a factory from Good Manufacturing Hygiene Practices (GMHP), proper use of in-can preservatives coupled with GMHP can dramatically minimize the chance of microbial tolerance development, and assure unspoiled products to customers.
Sunshine Biotech supplies to all industrial biocides formulators with high quality BIT technical ingredients. Besides of BIT, we also provide its derivative, like BBIT, MBIT etc.
Biocide Technical Ingredients,Biocide Formula,Biocide Ingredients,Biocide Liquid Nanjing Sunshine Biotech Co., Ltd , https://www.sunshine-bio.com
1. Disassembly of the die platen in the powder tableting machine: Pull out the powder retaining plate, remove the hopper, unscrew the set screw of the feeder, unscrew the fixed stud and spring of the feeder, remove the feeder, and unscrew the middle die plate The middle mold platen can be removed by fixing screws and spring washers. Installation: Refer to the reverse order above. Pay attention to alignment when screwing the feeder tightening screw. So as not to damage the wire hole of the feeder.
2. Disassembly of the punching rod on the powder tableting machine: Loosen the connecting rod lock nut, turn the upper punching rod to disengage it from the connecting rod, turn the handwheel to raise the eccentric wheel shell to the high position of the zui, turn the eccentric shell to make the joint The rod is swung up to the front and the upper punch rod can be pulled out from the upper of the mold frame hole. Installation is performed in the reverse order described above.
3. Disassembly of the lower punching rod: Unscrew the lower punching fixing screw, the butterfly screw and the gear pressing plate rotate the adjusting gear, so that the lower punching core rod is lowered and taken out from the bottom hole of the fuselage. Installation: Refer to the reverse order above.
4. Connecting rod removal: first remove the upper punching rod, then remove the wire retaining ring on the connecting rod pin, take out the connecting rod pin, and then take off the connecting rod. Installation: Follow the reverse order above.
5. Large pulley, pinion and bridge axle disassembly: lower the V-belt, unscrew the right end of the bridge shaft and the washer (in the fuselage), and pull the large pulley together with the pinion and the bridge shaft. Then, the bridge shaft can be pulled out of the wheel hole. (The large pulley is integrated with the pinion and the bushing, and generally does not need to be disassembled). Installation: Refer to the reverse order above.
6. Disassembly of the spindle of the powder tableting machine: The dismantling of the spindle should be carried out by two people. First remove the large pulley, then unscrew the nut to remove the lever, lever shaft and filling roller. (Remove the handwheel and camshaft if necessary) Remove the protective cover, unscrew the screws and washers, and use a wooden hammer to hit the non-working surface inside the large gear (not significant). Remove it (be careful not to lose the lifting roller), then hit the shaft end with a wooden hammer and a copper rod (be careful not to damage the shaft end screw hole), while holding the other end of the shaft and holding the eccentric wheel shell, slowly The spindle is removed. Installation: Refer to the reverse order above.
Brief analysis of disassembly and installation of main parts of powder tableting machine
Disassembly and installation of the main components of the powder tablet press: