With the development of scale, intensive and efficient agriculture, plant protection machinery is playing an increasingly important role. In order to better use the performance of the 3HH-36 stretcher-type high-efficiency motorized sprayer, the following points should be paid attention to during actual use. Soybean Sauce,Chili Bean Sauce,Thai Sweet Chilli Sauce,Best Sweet And Sour Sauce KAIPING CITY LISHIDA FLAVOURING&FOOD CO.,LTD , https://www.lishidafood.com
1. Assemble the implements according to the instructions, and check the correct position of each component, tighten the bolts, run the belts and pulleys flexibly, and ensure that the protective cover is in good condition.
2, according to the specification on the specification to add lubricants to the crankcase to the required oil level, after each use must be checked, and in accordance with the provisions of the gasoline engine inspection and add oil.
3, start the engine (how to start to see the instructions), run at low speed for 10-15 minutes, if you see there is water and no abnormal sound, you can gradually increase to the rated speed, and then press the pressure relief handle, and step by step clockwise Tighten the regulator wheel to increase the pressure so that the pressure is indicated to the required working pressure (usually 2.5-3.5 MPa) and tighten the nut.
4. The plunger pump grease cup should be filled with butter at any time, and the butter cup should be rotated down 2 to 3 times every two hours.
5, after the completion of daily operations should be under the use of pressure, continue to spray with water for 2 to 5 minutes, cleaning the pump and the pipeline of residual liquid, to prevent the internal residual liquid corrosion of the body.
6, remove the water filter and spray hose, open the water switch, press the pressure relief handle, loosen the pressure regulator handwheel, so that the pressure regulating spring is in a relaxed state, rotate the engine or pump by hand to eliminate the pump memory water, And scrub the surface dirt on the unit.
7. According to the instruction manual, regular replacement of engine and piston pump crankcase oil. If the crankcase is too dirty, use diesel to clean the cavity and add oil.
8. At the end of the prevention and control season, when the machine tool is stored for a long time, the water in the pump should be completely eliminated to prevent the mechanical parts from being corroded and freeze-dried during the cold, and to remove the V-belt, spray gun, hose, mixer, strainer, etc. Clean and air dry, and hang as much as possible. Put the fuel and oil in the net gasoline engine.
9. Pay attention to the use of the liquid pump can not be dehydration operation, so as not to damage the V-shaped apron and plunger, especially when starting and transferring.
10. Each time the machine is turned on or shut down, the pressure relief handle should be set at the pressure relief position.