One, clutch slip 1. Phenomenon: Low-grade start is slow, high-grade start is difficult, and sometimes jitter occurs; tractor traction is reduced; when the load increases, the vehicle speed fluctuates, or even stops, but the sound of the internal combustion engine does not change; when the clutch is overheated, the friction plate smokes, and There is a burning smell. 2. Causes and remedies: 1 There is oil on the surface of the friction plate. Mainly due to oil seals and other sealing devices damaged, leakage of oil, or improper maintenance, due to excessive oil injection. The source of oil contamination should be identified and eliminated before cleaning. 2 The clutch clearance is too small or there is no clearance. Should be readjusted. 3 The pressure spring breaks or the elastic force weakens. Replace the spring. 4 Wear plate wear. If the friction film is eccentrically worn, severely damaged or too thin, the rivet head is exposed and should be replaced; if the wear is not great, the depth of the rivet is not less than 0.5 mm, and it may not be changed. However, if the rivets loosen, they should be riveted or replaced with new rivets. If the friction plate burns lighter, it can be smoothed with sandpaper. 5 The warpage of the driven plate is deformed, and the unevenness of the flywheel and the pressure plate plane is too large. Correct the repair. The 6 return spring is loose or broken and should be replaced. Second, the clutch is not clear 1. Phenomenon: When the clutch pedal is stepped to the end, the power cannot be completely cut off, it is difficult to file or there is a strong sound of teeth. 2. Cause and remedy: 1 The clutch free stroke is too large, the small brake separation clearance is too small (Eastern Red - 75 drag), or the main clutch separation gap is too small (double acting clutch), resulting in clutch work stroke is insufficient, so that the clutch is not separated Clear, should be adjusted correctly. 2 The inner ends of the three separate levers are not on the same plane, and individual compression springs become soft or break, causing the pressure plate to be skewed when disengaged, and the clutch is not separated clearly. Should adjust or replace the spring. 3 Due to severe wear of clutch bearings and other reasons, the concentricity of the crankshaft and the clutch shaft is damaged, causing the yaw of the driven plate; the warping and deformation of the driven plate steel, the breakage of the friction plate, etc., will cause the clutch to separate and the driven plate There is still contact with the active part, making the clutch unclear. The deflection of the driven plate should be further identified and eliminated. If necessary, correct the driven steel plate and replace the friction plate. 4 Due to over-thickness and improper installation of the friction plates, the effective working stroke of the clutch is reduced and the separation is not clear. Should identify the reason for exclusion. Excessive thickness of the friction plate should be replaced, or be compensated by adding gaskets between the clutch cover and the flywheel (the thickness of the gasket should not exceed 0.5 mm). Frozen CPDTO red shrimp Cpdto Shrimp,Cpdto Red Shrimp,Frozen Cpdto Red Shrimp,Delicious Cpdto Red Shrimp Zhoushan Junwei Aquatic Products Co., Ltd. , https://www.junweiaquatic-intl.com