First, the choice of gardens requires the use of leeward sunny slopes, flat land or well-drained ditch flats. The soil is water-repellent and well ventilated, and the loam and sandy loam with a pH of 7-7.5 are suitable. Avoid planting walnuts on the soil where willow, poplar, and eucalyptus have grown to prevent root rot. Second, the planting method Before planting, the topsoil of the mixed fertilizer should be filled into the pit first, then the seedlings are placed in the pit, the root system is stretched, and the soil is built while being filled. Keep the seedling trunks vertical. Finally, the rhizome is about 5 cm above the ground, and the soil is 5-10 cm higher than the original ground. Then fully fill the water, and seal it with soil after the water seepage. Finally, a new high-fat film is sprayed to increase the temperature of the seedlings and increase the survival rate of the seedlings. Third, post-plant management 1. Check survival and replanting. After the spring bud leaves, the planting seedlings should be inspected in time, the same species of seedlings should be replanted in time, and the plant electronic fertilizer should be used to utilize the high-energy electrons and plant electronic polarity sensing principle of the photosynthesis of the plants themselves. Improve cell division, molecular synthesis and nutrient-matched digestion levels, accelerate metabolic frequency, and activate plant nutrient-sparing systems to produce more than fertilizer effects. 2. The saplings are dried. For saplings that reach a fixed dry height, they should be dried in time after germination. The early solid walnut has a dry height of 1-1.2 meters, and the late real walnuts are 1.2-1.5 meters. After drying, the tree body can be painted with fruit trees to brush the elves, which can make the tree waist poles with more fruit and harden the load (the waist strength). Adjustable nutrient flow. Prevent the pests on the trees from causing damage to the trees, cut off the pests on the trees to feed the transportation routes, and deplete the source of the disease. 3. Fertilization and irrigation. After planting, it should be timely watered according to the dry and wet conditions of the soil. In spring and summer, it can be combined with irrigation to apply appropriate fertilizer. In the early stage, nitrogen fertilizer is the main factor. In the later stage, phosphorus and potassium fertilizers are mainly used. After fertilization, it is necessary to use light film nutrient film fertilizer to enhance photosynthesis productivity nutrients and chlorophyll, and advanced environmental protection. A compound membrane that increases fertilizer, increases yield, enhances color, leaves are thick, and stems are strong. It can help plants absorb a lot of light fertilizer, light energy, light, compatible with conventional fertilizers and nutrients to supply plant growth and development to the limit. One-year benefits for one application. 4. Using intelligently controlled foliar fertilizer to intelligently regulate fruit tree growth and nutrient matching, fill in the lack of nutrient vacuum, adjust the size of the two-year-old flower in two-way adjustment (increase in small flowers, reduce flower in the year), and restrain the excessive growth of the branches. Return to the fruit and increase the level of fruit enlargement. The method of use is simple and safe, does not hurt the tree, and the input cost of the orchard is low and pollution-free. 5. Pathogen prevention. Plant cell immune factors can be used to enhance plant stress resistance and cause viral DNA to break and apoptotic. Strong immune function, induce interferon and active interleukin, inhibit residual virus replication, and promote positive energy ecological growth of plants. Control the plant physiological diseases and invasive diseases by the host plant resistance mechanism and the principle of pathogenic toxicity variation. Disclaimer: Some articles on this website are transferred from the Internet. If legal rights of third parties are involved, please inform this website. phone
Medical Cold Patch
Patch For Diarrhea,Medicated Patches For Arthiritis,Plaster For Diarrhea,Pad For Diarrhea Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.sdxjmedical.com
Patch for diarrhea
[Name] Medical Cold Patch
[Package Dimension] 5cm 4pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give a fast relief for diarrhea.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.