The Manual Resuscitator is a small portable ventilator used for emergency rescue both inside and outside the hospital. This product is used by medical personnel and personnel with short-term training in emergency situations, and can be used in emergency rescue locations and during the transportation of patients. Manual Resuscitator Manual Resuscitator,Reusable Manual Resuscitators,Manual Oxygen Resuscitator,Oxygen Regulator, Oxygen Tank Regulator Ningbo Queen Electronic Science Technology Co., Ltd , https://www.queenmeds.com
1. Check if the oil level of the disperser is added to the specified position, the low should be added to the specified oil level, and the high should be placed to the specified position.
2. Check if the V-belt is properly tightened.
3. The impeller should be rotated flexibly by hand, without friction.
4. Check whether the fasteners are loose and whether there is leakage in each sealing part.
5. Turn on the main motor of the disperser and check if the direction of the agitation is the same as the direction specified by the equipment.
6. Confirm that the above inspection work is correct before driving.
Second, driving
1. Place the impeller in the center of the disperser container, and lower the button to the low position or the required position.
2. The two handles must be locked before driving.
3. Open the main motor and press the button according to the operation speed.
4. The current should be paid attention to during the operation of the dispersing machine. If overload operation is found, stop the inspection and take measures to continue the operation of the dispersing machine.
Third, parking
1. Stop the main motor first, so that the impeller stops rotating.
2. Open the disperser up button to raise the spindle impeller to the top of the container and clean the impeller.
Fourth, the daily maintenance of the disperser:
1. The V-belts should be equal in length and length, placed in the transmission box, and tightened properly. Tighten the bolts of the skateboard and cover the upper cover.
2. If the equipment is not used for long-term parking, the power must be cut off, all scrubbed clean, oil is injected into each lubrication part, and the main shaft and cylinder are oiled and rustproof.
3. Use 46# hydraulic oil for the fuel tank, replace it once every six months, and clean the fuel tank. The filter is cleaned once a month and cleaned once every two or three days after oil change.
4. The gears, bearings, balls, shafts, bushings and cylinders of the rotating part of the dispersing machine are filled once a week. If overheating or abnormal noise is found during use, it should be checked in time.
5. If the thermal relay is stopped due to overload, the “reset†button of the thermal relay must be removed to continue operation.
6. The AC contactor is inspected once every six months, and the equipment is used once a year for inspection.
7. Regularly check the wearing parts of the dispersing machine, such as bearings, oil seals, etc., and find that there is wear and replace immediately.
( Source: Yizhan Instrument Exhibition Network )
Operation method of the disperser
First, the preparation work before the dispersing machine drives